Crown Victoria V8-4.6L SOHC VIN W (2005)
Evaporative Emissions Hose: Service and Repair
FUEL VAPOR CONTROL TUBE ASSEMBLY VALVE
Removal and Installation
1. Remove the fuel tank.
2. CAUTION: The fuel vapor control valve tube assembly and the fuel vapor vent valve are removed as one piece. Do not attempt to
separate.
Remove the fuel vapor control valve tube assembly.
-
Apply upward pressure on the fuel vapor vent valve.
-
Remove the fuel vapor control valve tube assembly.
3. Remove the fuel vapor control valve.
-
Push down and rotate counterclockwise.
-
Remove the fuel vapor control valve.
4. NOTE: Lubricate all O-ring seals with P80 Rubber Lubricant Emulsion or equivalent meeting Ford specification WSE-M99C45-A2.
To install, reverse the removal procedure.
-
Leak test the system. See: Testing and Inspection/Evaporative Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification
Drive Cycle