Crown Victoria V8-4.6L SOHC VIN W (2005)
Shift Interlock Solenoid: Service and Repair
Brake Shift Interlock Actuator - Floor Shifter
Brake Shift Interlock Actuator - Floor Shifter
Removal and Installation
1. WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing
or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Disconnect the battery ground cable. Wait at least one minute before proceeding with the procedure to allow the backup power supply to
deplete its energy.
2. Remove the instrument panel finish panel and disconnect the electrical connector.
3. Lift the console finish panel up and remove the finish panel.
4. Push the shift handle bezel down and disconnect the TCS harness.