Crown Victoria V8-4.6L SOHC VIN W (2005)
Body Control Module: Service and Repair
Driver Door (DDM) Module
MODULE - DRIVER DOOR (DDM)
Removal and Installation
1. CAUTION: Prior to removal of the driver door module (DDM), it is necessary to upload module configuration information to a
diagnostic tool. This information needs to be downloaded into the new module once installed.
Disconnect the battery ground cable.
2. Remove the driver door trim panel.
3. Remove the driver door module (DDM).
1
Disconnect the electrical connector.
2
Remove the screws.
3
Release the locking tab.
4. CAUTION: Once the new DDM is installed, it is necessary to download the module configuration information from the diagnostic tool
into the new module.
To install, reverse the removal procedure.
-
Check for correct operation.
