Crown Victoria V8-4.6L SOHC VIN W (2005)
5. Remove the rear front seat track covers.
6. NOTE: When installing, make sure the safety belt anchor is in place on the rear inboard stud before tightening the nut.
Separate the front center safety belt and tongue anchor from the mounting stud and seat.
-
Remove the nuts.
-
Tilt the driver seat forward enough so the center safety belt anchor clears the mounting stud.
-
Separate the anchor from the stud and seat.
7. NOTE:
-
Make sure the safety belt and tongue or safety belt buckle are accessible to the passenger after installation.
-
Make sure the safety belt webbing is not twisted prior to installation.
Route out and remove the safety belt and tongue from the seat cushion opening.
8. To install, reverse the removal procedure.
Seats with side air bags
9. Repower the SRS.
All seats
10. Check the active restraints for correct operation.
