Crown Victoria V8-4.6L SOHC VIN W (2005)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Front
Wheel Speed Sensor Front
Removal and Installation
CAUTION: The front wheel speed sensor acts as a wheel bearing seal. Do not operate the vehicle without the front wheel speed sensor installed.
1. Disconnect the front wheel speed sensor electrical connector.
2. WARNING: The electrical power to the air suspension system must be turned off prior to hoisting, jacking, or towing an air suspension
vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during
these operations. Failure to follow these instructions may result in personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
3. Disconnect the routing clips.
4. Clean the area around the front wheel speed sensor of all dirt and foreign material before removal.
5. CAUTION: Be sure to remove all dirt and foreign material from the area before installation.
Remove the front wheel speed sensor.
^
Using a suitable tool, push the tabs inward.
^
Remove the sensor out of its housing.