Crown Victoria V8-4.6L SOHC VIN W (2005)
Engine Temperature Sensor: Service and Repair
Removal and Installation
Warning: If equipped with fire suppression system, depower the system.
1. Remove the intake manifold.
Note: The tip of the cylinder head temperature (CHT) sensor contacts the cylinder head at the bottom of the hole. When removed, it will be slightly
crushed. This is a normal condition.
2. Remove CHT sensor.
1. Disconnect the CHT electrical connector.
2. Remove and discard the CHT sensor.
Warning: If equipped with fire suppression system, repower the system.
Note: The CHT sensor is not to be reused. Always install a new sensor.
3. To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
