Crown Victoria V8-4.6L SOHC VIN W (2005)
19. Connect the driver air bag module
1. Connect the horn electrical connector.
Caution: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the
electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module.
2. Connect the driver air bag module electrical connectors as noted during removal.
3. Install the driver air bag module electrical wiring into the driver air bag wiring clip.
Note: With the driver air bag module held as close to the steering wheel as possible, take up the slack in the wiring by gently tucking any excess length
into the pocket at the bottom of the steering wheel before rocking the driver air bag module into place.
