Crown Victoria V8-4.6L SOHC VIN W (2005)
13. Loosen the exhaust clamp and remove the LH exhaust pipe.
14. Install a suitable transmission jack.
15. Remove the RH side crossmember bolts.
16. Disconnect the LH side crossmember.
1
Loosen but do not remove the LH side crossmember bolts.
2
Remove the LH side crossmember bolt.
17. Remove the bolts and remove the parking brake cable bracket and position aside.
18. NOTE: The crossmember is a press fit in the crossmember pocket, it may be necessary to pry the crossmember out of the crossmember pocket.
Be careful not to damage the crossmember. Only the RH side of the crossmember will need to be lowered in order to gain access to the rear
extension housing.
