Crown Victoria V8-4.6L SOHC VIN W (2005)
Removal
1. Remove the differential carrier assembly.
2. Index-mark the driveshaft flange and pinion flange for correct alignment during installation.
3. Remove the 4 driveshaft flange bolts.
4. CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components
to disconnect the driveshaft centering socket yoke from the pinion flange. Pry only in the area shown with a suitable tool to disconnect the
driveshaft centering socket yoke from the pinion flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the pinion flange.
^
Using mechanic's wire, position the driveshaft aside.
5. CAUTION: Discard the nut after removal. Use a new nut during installation.
