Crown Victoria V8-4.6L SOHC VIN W (2005)
8. Install a new bearing cup.
1
Start a new bearing cup into the driveshaft yoke.
2
Position a new spider in the driveshaft yoke.
3
Install the driveshaft into the U-Joint Tool.
4
Press the bearing cup 6.3 mm (0.25 inch) below the yoke surface.
9. NOTE: Use the yellow snap rings supplied in the universal kit. If difficulty is encountered installing the yellow snap rings, install the black snap
rings also supplied in the kit.
Remove the driveshaft from the U-Joint Tool and install the snap ring.
10. Repeat Steps 8 and 9 for the opposite side.
11. Install a new bearing cup.
1
Start a new bearing cup into the driveshaft slip-yoke.
2
Install the driveshaft into the U-Joint Tool.
3
Press the bearing cup 6.3 mm (0.25 inch) below the yoke surface.
12. NOTE: Use the yellow snap rings supplied in the universal kit. If difficulty is encountered installing the yellow snap rings, install the black snap
rings also supplied in the kit.
