Crown Victoria V8-4.6L SOHC VIN W (2005)
8. Clean the interior and exterior of the windshield glass surface with a non-alcohol based glass cleaner.
9. Cut the urethane adhesive applicator tip to specification.
10. NOTE:
-
Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and continuous bead.
-
Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
Apply urethane adhesive over top of the existing urethane adhesive.
-
Apply the urethane adhesive to the top and sides of the windshield from the interior of the vehicle.
-
Apply the urethane adhesive to the bottom of the windshield from the exterior of the vehicle.
11. NOTE: The urethane adhesive must cure for a minimum of 1 hour before testing for air or water leaks.
After the urethane has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as
necessary.
12. Install the front portion of the headliner.
13. If equipped, install the roof opening panel headliner retainer.
14. If equipped, install the overhead console.
15. Install the LH and RH windshield side garnish mouldings.
