E 150 V8-4.6L (2007)
^
Stage 1: Tighten to 20 Nm (15 ft. lbs).
^
Stage 2: Tighten an additional 60 degrees.
7. Lubricate the engine front cover and the crankshaft front seal inner lip with clean engine oil.
8. Using the special tools, install a new crankshaft front seal.
9. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal
surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to
follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
10. Using the special tool, install the crankshaft pulley.