E 150 V8-4.6L (2007)
PROM - Programmable Read Only Memory: Customer Interest
Engine Controls - DTCs P0606/P0607/P0731 On Cold Start
TSB 10-18-5
09/27/10
4.6L - DTCS PO6O6/PO6O7/PCM ERROR OR P0731 1ST
GEAR RATIO ERROR WHILE COLD
FORD:
2007-2008 E-150
ISSUE
Some 2007-2008 Econoline vehicles equipped with a 4.6L engine may exhibit diagnostic trouble codes (DTCs) P0606, P0607 PCM error or P0731 shift
solenoid 1st gear ratio error. Typically occurs during a cold start event where vehicle throttle pedal has been partially depressed and accompanied by an
immediate selector lever moved to the drive position. The driver may report that the O/D light flashing on the shift lever.
ACTION
Reprogram the powertrain control module (PCM) to the latest calibration using IDS release 68.1 and higher. This new calibration is not included in the
VCM 2010.7 DVD. Calibration files may also be obtained at the website.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
101805A
2007-2008 Econoline 4.6L:
0.3 Hr.
Check For DTCs And
Reprogram The PCM (Do
Not Use With Any Other
Labor Operations)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
RECALEM
04
Disclaimer
