E 150 V8-4.6L (2007)
Seat Belt: Service and Repair
Safety Belt - Rear 4-Passenger Bench Seat
SAFETY BELT - REAR 4-PASSENGER BENCH SEAT
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters, [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should
be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Remove the bolt and the LH safety belt buckle assembly.
-
To install, tighten to 40 Nm (30 lb-ft).
2. Remove the bolt and the center safety belt assembly.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the bolt and the RH safety belt buckle assembly.
-
To install, tighten to 40 Nm (30 lb-ft).
4. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.