E 150 V8-4.6L (2007)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure (EOP) Switch
Engine Oil Pressure (EOP) Switch
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the engine oil pressure (EOP) switch wiring harness retainer and electrical connector.
3. Remove the EOP switch.
^
To install, tighten in 2 stages.
-
Stage 1: Tighten to 14 Nm (10 ft. lbs).
-
Stage 2: Tighten an additional 180 degrees.
4. To install, reverse the removal procedure.