E 150 V8-4.6L (2007)
8. Lower the transmission enough to gain access to the turbine shaft speed (TSS) sensor and intermediate shaft speed sensor.
9. Disconnect the TSS and intermediate shaft combination speed sensor electrical connector.
10. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the
transmission.
Remove the TSS and intermediate shaft combination speed sensor.
1
Remove the bolt.
2
Remove the TSS and intermediate shaft combination speed sensor.
Installation
1. Install the TSS and intermediate shaft combination speed sensor.
1
Lubricate the O-ring with clean automatic transmission fluid and install the TSS and intermediate shaft combination speed sensor.
2
Install the bolt.
^
Tighten to 9 Nm (80 inch lbs.)