E 150 V8-4.6L (2007)
3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the 4 driveshaft bolts.
^
Tighten to 103 Nm (76 ft. lbs.)
Extension Housing Gasket
Extension Housing Gasket
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. NOTE: The output shaft and driveshaft are a balanced assembly.
Mark the driveshaft flange and the rear pinion flange for correct alignment during assembly.
3. Remove the 4 bolts.