E 150 V8-4.6L (2007)
Transmission Speed Sensor: Service and Repair
Torqshift Automatic Transmission
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the output shaft speed (OSS) sensor electrical connector.
3. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the
transmission.
Remove the OSS sensor.
1
Remove the bolt.
2
Remove the OSS sensor.
Installation
1. Install the OSS sensor.
1
Lubricate the O-ring and install the OSS sensor.
2
Install the bolt.
^
Tighten to 9 Nm (80 inch lbs.)
2. Connect the OSS sensor electrical connector.