E 150 V8-4.6L (2007)
Wiring Harness: Service and Repair
TorqShift Automatic Transmission
Internal Harness Service
Removal
1. Remove the main control solenoid body.
2. Disconnect the internal wiring harness.
1
Remove the 2 screws.
2
Disconnect the transmission fluid temperature sensor electrical connector.
3
Disconnect the solenoid electrical connectors.
3. Remove the bulkhead connector O-ring.
4. Lift the tab twisting the bulkhead connector, and push it through the solenoid body, and remove the wire harness.
Installation
1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
2. Connect the internal wiring harness.
1
Install the 2 screws.
2
Connect the transmission fluid temperature sensor electrical connector.
3
Connect the solenoid electrical connectors.