E 150 V8-4.6L (2007)
Slip Yoke: Service and Repair
Driveshaft Slip Yoke
Special Tool(s)
Material
Disassembly
1. CAUTION: Do not, under any circumstance, clamp the driveshaft in the jaws of a vise or similar holding fixture. Denting or localizing
fracture can result, causing driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench. Do not damage the tubes.
2. Remove the slip-yoke from the driveshaft.
1
Cut and discard the slip-yoke boot clamps.
2
Remove the slip-yoke from the driveshaft.
3. Remove the slip-yoke boot from the driveshaft.
^
Inspect the boot for wear or damage. Install a new slip-yoke boot as necessary.
4. Inspect the lubricant on the driveshaft splines and in the driveshaft slip-yoke for contamination. If contaminated, inspect the driveshaft splines and
the slip-yoke for wear. Install new components as necessary.