E 150 V8-4.6L SOHC VIN W (2004)
5.
NOTE: Two (2) sheets of labels are provided in the service kit. One sheet is for 2003 model year vehicles and one for 2004 model year vehicles.
Use the appropriate model year sheet and discard the remaining sheet. See Figure 2.
Each sheet contains two (2) labels:
^
One (1) label for the top of the Power Distribution Box (PDB). (WARNING LABEL) One (1) label to install in the Owner Guide. (30A**
LABEL)
Clean the PDB cover and install the supplied PDB cover label. See Figure 3.
6.
Locate the vehicle Owner's Guide. In the FUSES AND RELAYS section under Roadside Emergencies, locate the PDB fuse identification chart.
7.
Apply the supplied "30A **" label over the 60A** designation for the 4WABS module system fuse. See the samples below. Return the Owner's
Guide to its original location.
8.
Go to HEAT SHIELD INSTALLATION.
^
Be sure to follow the correct procedure based on whether or not the vehicle has Hydro-boost brakes.
HEAT SHIELD INSTALLATION - VEHICLES WITHOUT HYDRO-BOOST
1.
If required for access to install the heat shield, disconnect the speed control deactivation switch located at the bottom of the master cylinder.
