E 150 V8-4.6L SOHC VIN W (2004)
Power Seat Switch: Service Precautions
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
The belt and buckle assembly pretensioner is a pyrotechnic device. Always wear safety glasses when servicing an air bag-equipped vehicle
and when handling a belt and buckle assembly pretensioner.
-
The belt and buckle assembly pretensioner is a pyrotechnic device. Never probe the connectors on the belt and buckle assembly
pretensioner. Doing so can result in belt and buckle assembly pretensioner or air bag deployment and can result in personal injury.
-
The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
-
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
-
To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes and instructions in the supplemental restraint
system deactivation/reactivation procedure.
