E 150 V8-4.6L VIN W (2006)
2. Use a suitable suction device to remove the brake fluid from the brake master cylinder reservoir.
3. Remove the coolant reservoir bolts and position the reservoir aside.
^
To install, tighten to 10 Nm (89 inch lbs.).
4. Disconnect the brake fluid level switch electrical connector.
5. Disconnect the speed control deactivator switch electrical connector.
6. Disconnect the master cylinder tube fittings.
^
To install, tighten to 18 Nm (13 ft. lbs.).
^
For vehicles with traction control and stability assist, tighten to 28 Nm (21 ft. lbs.).
7. Remove the nuts and the power steering line clamp.
^
To install, tighten to 9 Nm (80 inch lbs.).
8. NOTE: Discard the brake master cylinder nuts. They are a torque-prevailing type and cannot be reused.
Remove the brake master cylinder nuts.
^
To install, tighten to 26 Nm (19 ft. lbs.).
9. Remove the power steering line bracket.
10. Remove the brake master cylinder.
11. To install, reverse the removal procedure.
^
Bleed the brake system.