E 150 V8-4.6L VIN W (2006)
core orifice.
4. If the evaporator core orifice is broken, screw the end of the special tool into the broken orifice. Hold the T-handle stationary while rotating the
tool body to remove the evaporator core orifice.
Installation
1. Lubricate the evaporator core orifice O-rings with clean PAG oil and install the evaporator core orifice using the special tool.
2. Connect the evaporator inlet fitting.
-
Install a new O-ring seal.
-
Tighten to 18 Nm (13 lb-ft).