E 150 V8-4.6L VIN W (2006)
2. Remove the nut and disconnect the condenser outlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
Vehicles with 4.6L, 5.4L or 6.8L engine
3. Remove the engine air cleaner and the air cleaner outlet tube.
4. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
Disconnect the condenser outlet fitting.
-
Discard the O-ring seals.
-
To install, tighten to 39 Nm (29 lb-ft).
Vehicles with auxiliary A/C
5. Remove the 4 condenser-to-evaporator line bracket screws and the 4 condenser-to-evaporator line brackets.
6. Disconnect the auxiliary evaporator inlet line fitting.
-
Discard the O-ring seals.
All vehicles
7. Remove the evaporator inlet fitting bracket screw.
-
To install, tighten to 2 Nm (18 lb-in).
8. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
Disconnect the evaporator inlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 18 Nm (13 lb-ft).
9. Remove the condenser-to-evaporator line.
10. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Evacuate, leak test and charge the A/C system.