E 150 V8-4.6L VIN W (2006)
Pitman Arm: Service and Repair
Sector Shaft Arm Drag Link
Special Tool(s)
Removal and Installation
1. If equipped, remove the steering linkage damper.
2. Remove the RH outer tie-rod end cotter pin and nut.
^
Discard the cotter pin.
^
To install, tighten to 95 Nm (70 ft. lbs.).
3. Using the special tool, separate the RH outer tie-rod end from the wheel spindle.
4. Remove the inner tie-rod end cotter pin and nut.
^
Discard the cotter pin.
^
To install, tighten to 95 Nm (70 ft. lbs.).
5. Using the special tool, separate the inner tie-rod end from the sector shaft arm drag link.