E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
9. Position the windshield glass on the vehicle pinch weld and center the glass in the opening.
CAUTION: After replacing the urethane installed glass, the vehicle should not be driven until the urethane has cured. The curing times at
temperatures above 13°C (55°F) and relative humidity above 50% is 12 to 24 hours (decreasing at higher temperatures and lower humidities).
Inadequate curing of the urethane can adversely affect the strength of the urethane sealant bond.
10. Position the windshield glass stops on the vehicle. Adjust glass height and rivet the stops in position.
11. Wipe off any excess urethane sealant and apply a 6 mm (0.23 inch) bead of Pumpable Foam Dam ESB-M4G309-A between the windshield
header seal and the urethane sealant.
12. Fill cavity between both the LH and RH side of the windshield header seal and the sheet metal using RTV Sealer ESB-M4G92 for a total length of
50 mm (2 inches) from the base of the A-pillars.
13. Install the inside rear view mirror.
14. Install the roof trim panel.
15. Install (push on) the LH and RH A-pillar mouldings.
16. Install the cowl top vent panel.
17. Install the windshield wiper pivot arms.
