E 150 1/2 Ton Van V8-5.4L SOHC VIN L (1997)
2. Use the (A) Crankshaft Seal Replacer/Aligner to install the (B) crankshaft front seal into the (C)engine front cover.
3. Apply silicone to the Woodruff key slot on the crankshaft pulley.
^
Use Silicone Gasket and Sealant F6AZ-19562-A or equivalent meeting Ford specification WSE-M4G323-A6.
NOTE: If not secured within 4 minutes, sealant must be removed and the sealing area cleaned with solvent. Allow to dry until there is no sign of
wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil leakage.
4. Use the Crankshaft Damper Replacer to install the crankshaft pulley.
5. Tighten the crankshaft pulley bolt in four stages.
Stage 1: 90 Nm (66 ft. lbs.)
Stage 2: Loosen 360 degrees
Stage 3: 47-53 Nm (35-39 ft. lbs.)
Stage 4: Rotate 85-90 degrees