E 250 V10-6.8L VIN S (2005)
Turn Signal Switch: Service and Repair
Multifunction Switch
Removal
1. Disconnect the battery.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2. Insert a punch through the hole in the lower steering column shroud and push the ignition switch lock cylinder release tab while pulling out the
ignition switch lock cylinder.
3. NOTE: The steering wheel is removed for clarity.
If equipped, twist the tilt wheel handle and shank and remove.
4. Remove the upper and lower steering column shrouds.
1. Remove the screws.
2. Remove the lower steering column shroud.
3. Remove the upper steering column shroud.