E 250 V10-6.8L VIN S (2005)
Seat Belt Height Adjuster: Service and Repair
Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts
SAFETY BELT SHOULDER HEIGHT ADJUSTER WITH STRIPPED WELD NUTS
D-Ring Installation Kit
Special Tool(s)
1. Remove the shoulder safety belt height adjuster.
2. Use the half-inch drill with integral stop provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. NOTE: After each rotation, back off the tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
Apply a suitable lubricant to the M14 x 1.5 tap with integral stop provided in the D-Ring Installation Kit, and tap new threads.
