E 250 V10-6.8L VIN S (2005)
Seat Belt Retractor: Service and Repair
Retractor - Front Safety Belt and Tongue
RETRACTOR - FRONT SAFETY BELT AND TONGUE
Torx Bit, Safety Belt Bolt
Special Tool(s)
Removal
NOTE: Safety belt buckles, pyrotechnic safety belt buckle pretensioners, height adjusters, center adjust tongues and belts and retractors can be replaced
separately. However, if a safety belt assembly was in use during a collision, the belt and retractor must be replaced as well as the center adjust tongue and
belt and buckle assembly or the center adjust tongue and the cable and buckle assembly. When replacing safety belts and buckles, pyrotechnic safety belt
buckle pretensioners, height adjusters, safety cables and buckles, center adjust tongues and belts and retractors, use only the replacement parts specified
in the Ford Master Parts Catalogs for the make and model of the vehicle being serviced. Safety belt assemblies must not be interchanged between vehicle
models.
1. NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed,
install a new shoulder safety belt guide.
Remove the front shoulder safety belt guide cover.
2. Remove the shoulder safety belt guide.
1
Remove the shoulder safety belt guide nut.
2
Remove the shoulder safety belt guide.
3. On the driver side, remove the front door scuff plate, the body side trim finish panel, the front upper body side trim panel, and the front lower body
side trim panel.