E 250 V10-6.8L VIN S (2005)
12. If equipped, install the output shaft flange.
1. Install the output shaft flange.
2. Install a new bolt.
All vehicles
13. Install the rear driveshaft.
14. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
15. CAUTION: The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or
transmission failure.
With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the
transmission fluid level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is
achieved (fluid should be in the cross-hatched area of the fluid level indicator).