E 250 V10-6.8L VIN S (2005)
![background image](/ford/e_250/v10-6.8l_vin_s/Page-1633002.png)
5. Using a suitable press, remove the bearing from the driveshaft.
6. Using a suitable press, remove the dust slinger.
7. NOTE: Clean grease deposits, dirt and rust from the stub shaft. Inspect the stub shaft splices for nicks, gouges, or burrs. Remove with a file or
emery cloth. The driveshaft center bearing bracket must be installed with the deep flange rearward.
To assemble, reverse the disassembly procedure.
^
Lubricate the stub shaft spline with grease.