E 250 V8-4.6L SOHC VIN W (2004)
Brake Rotor/Disc: Service and Repair
Front
E-150
Brake Disc-E-150
Material
Removal
1. Remove the brake caliper anchor plate.
2. Remove the brake disc and hub as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the front wheel outer bearing retainer washer.
6
Remove the outer front wheel bearing.
7
Remove the brake disc and hub.
3. If necessary, resurface the brake disc and hub. Ford recommends on-vehicle brake disc machining. Follow the lathe manufacturer's instructions.
1
Remove the wheel hub grease seal.
2
Remove the inner front wheel bearing.
Installation