E 250 V8-4.6L SOHC VIN W (2004)
Shift Cable: Service and Repair
Selector Lever Cable and Bracket
Selector Lever Cable and Bracket
Removal and Installation
NOTE: The 4R70W transmission is shown, this procedure is also used for the 4R100 transmission.
NOTE: To prevent shift cable damage, do not apply force to the transmission shift cable assembly between the steering column shift tube bracket and
the steering column bracket.
1. Disconnect the shift cable.
1. Disconnect the shift cable from the steering column shift tube lever.
2. Carefully lift the locking tab and disconnect the shift cable from the steering column bracket.
2. Push the rubber grommet and the transmission shift cable through the bulkhead.
3. Position the vehicle on a hoist.
4. NOTE: To prevent shift cable damage, do not apply force to the shift cable between the transmission manual control lever and the shift cable
bracket.
Remove the shift cable.
1. Disconnect the cable at the manual control lever.
2. Press the lock tabs and remove the cable from the bracket.
3. Remove the cable from the locator clip.
5. Remove the shift cable bracket (all except vehicles equipped with 4.2L engine).
^
Remove the bolts.
^
Remove the shift cable bracket.