E 250 V8-4.6L VIN W (2006)
Rear Door Exterior Handle: Service and Repair
Door Handle
EXTERIOR DOOR HANDLE - SIDE AND REAR
Special Tool(s)
Special Tool(s)
Removal and Installation
All Doors
1. If equipped, remove the door trim panel.
Rear Door
2. Remove the 4 license plate housing screws.
3. Position the housing away from the door.
4. NOTE: The rear door exterior door handle is part of the license plate housing.
Disconnect the door lock cylinder actuating rod and the door latch cable and remove the license plate housing.
Side Door
5. NOTE: Use the special tool to install the exterior door handle assembly rivets.
Remove the 2 rivets.