E 250 V8-4.6L VIN W (2006)
Fill the rubber caliper sleeve boots with caliper grease.
4. Install the brake pads.
5. On E-150, install the brake pad retaining springs.
6. Attach the speed sensor wiring to the front brake hose.
7. CAUTION: Tighten the bottom caliper bolt before tightening the top caliper bolt.
CAUTION: Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.
Position the brake caliper and install the 2 bolts.
^
On E-150, tighten to 32 Nm (24 ft. lbs.).
^
On E-250, E-350, E-450, tighten to 31 Nm (23 ft. lbs.).
8. Fill the brake master cylinder reservoir with clean DOT 3 brake fluid.
9. Test the brakes for normal operation.