E 250 V8-4.6L VIN W (2006)
2. Position a piece of Plastigage across the bearing surface.
3. NOTE: Do not turn the crankshaft during this step.
Install and tighten to specifications, then remove the connecting rod bearing cap.
4. Measure the Plastigage to get the connecting rod bearing journal clearance. The Plastigage should be smooth and flat. A changing width indicates
a tapered or damaged connecting rod or connecting rod bearing.
^
If out of specification, install new components as necessary.
Connecting Rod - Side Clearance
1. Measure the clearance between the connecting rod and the crankshaft. Verify the measurement is within specification.
^
If out of specification, install new components as necessary.
Roller Follower Inspection
