E 250 V8-4.6L VIN W (2006)
Front Lean Correction Chart
10. Remove the high side front coil spring.
11. Compare the height of the original front coil spring with a new one with the same part number. Note the difference.
12. If the original front coil spring exceeds the height of the new spring by 13 mm (1/2 inch), install the new front coil spring in the vehicle.
13. If the original front coil spring is shorter than the new spring by at least 13 mm (1/2 inch), remove the low side front coil spring from the vehicle.
14. Compare all 3 front coil springs and select the 2 most evenly matched for installation.
15. From the 2 most evenly matched coil springs, select the tallest and install it on the lower side of the vehicle. Install the shorter of the 2 on the
higher side of the vehicle.
Rear lean correction
16. Using the recorded rear wheel well difference numbers, the recorded rear chassis ride height difference numbers and the following repair action
chart, determine what repair action is needed to correct the vehicle lean condition.
Rear Lean Correction Chart
^
If shim installation is required, continue with this procedure.