E 250 V8-4.6L VIN W (2006)
Hose/Line HVAC: Service and Repair
Compressor Manifold and Tube Assembly
COMPRESSOR MANIFOLD AND TUBE ASSEMBLY
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. NOTE: Access the compressor manifold and tube assembly bolt from the RH front fender well, between the frame and body.
Loosen the compressor manifold bolt and detach the compressor manifold and tube assembly from the A/C compressor.
-
Discard the O-ring seals.
-
To install, tighten to 21 Nm (15 lb-ft).
4. Remove the air cleaner assembly.
5. Disconnect the high-pressure cutoff switch electrical connector.
6. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.