E 250 V8-4.6L VIN W (2006)
![background image](/ford/e_250/v8-4.6l_vin_w/Page-1465001.png)
Accelerator Pedal: Service and Repair
ACCELERATOR PEDAL
Removal and Installation
CAUTION: The accelerator pedal and position sensor assembly is a non-adjustable, calibrated unit and must be handled with care.
1. Disconnect the battery ground cable.
2. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the accelerator pedal position sensor electrical connector.
3. Remove the 2 bolts and slide the accelerator pedal and position sensor assembly up and off the anchor bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
4. To install, reverse the removal procedure.