E 250 V8-4.6L VIN W (2006)
Child Seat Tether Attachment: Service and Repair
Child Safety Seat Tether Anchor - LATCH, Rear Bench
CHILD SAFETY SEAT TETHER ANCHOR - LATCH, REAR BENCH
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters, [if
so equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.
1. Remove the seat.
2. Remove the seat cushion.
3. Remove the 6 bolts and the lower anchors and tethers for children (LATCH).
-
To install, tighten to 25 Nm (18 lb-ft).
4. To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.