E 250 V8-4.6L VIN W (2006)
8. Install the wire harness and install the 2 retaining clips to the rear of the crossmember.
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a sensor. hoist.
2. Disconnect the output shaft speed (OSS) sensor.
3. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of debris to prevent contamination of the
transmission.
Remove the OSS sensor.
1
Remove the bolt.
2
Remove the OSS sensor.
Installation