E 250 V8-4.6L VIN W (2006)
1. Install the retainer and the one bolt hand-tight.
2. Lower the transmission while aligning the retainer studs with the holes in the crossmember. Allow the full weight of the transmission to rest on the
crossmember.
3. Remove the high lift transmission Jack.
4. Install the hanger and the insulator and retainer to extension housing bolts.
^
Tighten to 95 Nm (70 ft. lbs.).
5. Install the insulator and retainer to crossmember nuts.
^
Tighten to 95 Nm (70 ft. lbs.).
6. Remove the supports and lower the vehicle.