E 250 V8-4.6L VIN W (2006)
![background image](/ford/e_250/v8-4.6l_vin_w/Page-1897003.png)
3. Lubricate the slip-yoke spline with grease.
4. NOTE: Depending on the paint markings, there are 2 methods of indexing the driveshaft and the output shaft.
Install the driveshaft.
1
Preferred method - align the factory-made paint marks on the output shaft and driveshaft and position the driveshaft in the transmission.
2
Alternate method - align the index marks and position the driveshaft in the transmission.
5. CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply sealer to the threads of the original bolts.
CAUTION: The driveshaft flange yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the flange, tighten the
bolts evenly in a cross pattern in the sequence shown.
Position the driveshaft flange yoke on the pinion flange with the index marks aligned and install the driveshaft-to-pinion flange bolts.
Driveshaft - Rear Two-Piece