E 250 V8-4.6L VIN W (2006)
4. Inspect the lubricant on the driveshaft splines and in the driveshaft slip-yoke for contamination. If contaminated, inspect the driveshaft splines and
the slip-yoke for wear. Install new components as necessary.
Assembly
1. Position the new small slip-yoke boot clamp on the driveshaft stub shaft.
2. Slide the small opening end of the slip-yoke boot on the driveshaft stub shaft, as far as it will travel.
3. Using the special tool, crimp the slip-yoke boot clamp.
4. Install the slip-yoke on the driveshaft.
1
Pull the slip-yoke boot toward the driveshaft. Lubricate the driveshaft splines with approximately 10 grams (0.24 oz) of lubricant.
2
Position the new large slip-yoke boot clamp.
3
Align the blind splines, and install the slip-yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.
