E 250 V8-5.4L (2008)
32. NOTE: The on-center torque must be 0.28 - 0.79 Nm (2.5 - 7 lb-inch) greater than preload torque without exceeding a total of 2.15 Nm (19
lb-inch). The on-center torque minus the preload torque is the meshload torque.
If necessary, carry out the following steps to adjust the on-center torque.
33. NOTE: Rotate the meshload adjusting screw clockwise to increase the on-center torque and counterclockwise to decrease the on-center torque.
Rotate the meshload adjusting screw until the on-center and meshload torque readings fall within the specified values.
34. While holding the meshload adjusting screw, tighten the meshload adjusting screw locknut to 31 Nm (23 lb-ft).
35. Install the steering gear.