E 250 V8-5.4L SOHC VIN L (2004)
^
Use the Pitman Arm Puller to separate the steering sector shaft arm drag link.
6. NOTE: The front wheels should not touch the ground.
Lower and support the front of the vehicle.
7. NOTE: Reset the steering gear meshload only if the measured rotating torque for total on-center load is less than specification.
Attach a lbs./inch torque wrench to the bolt and measure the steering gear meshload from center.
8. Adjust if not within specification.
9. Adjust the sector shaft to proper rotating torque.
1
Hold the sector shaft and loosen the lock nut.
2
Adjust the sector shaft.