E 250 V8-5.4L SOHC VIN L (2004)
3. Remove the reverse servo assembly.
1. Remove the reverse band servo cover.
2. Remove the reverse band servo piston and rod.
3. Remove the reverse band servo spring.
Installation
NOTE: This is not an ordinary installation procedure and does not compensate for band wear.
1. NOTE: Lubricate the reverse piston seal to facilitate assembly and prevent damage to the seal.
Install the reverse servo return spring and piston.
^
Do not install the piston cover.
2. Install the special tool and tighten the band apply bolt.
3. Attach the special tool to the transmission.
