E 250 Van L6-300 4.9L (1984)
template with the printed side downward. The template locates off of one of two existing holes in the radius arm. The E100-350 template is shaped
to match the contours of the radius arm.
Figure 9 - HOLE DRILLING INSTRUCTIONS - CAM ATTACHMENT TO LOWER FLANGE RADIUS ARM
3.
With template secure, make a punch mark at the center of the small hole inside the printed circle. Scribe the slot printed/cut-out on the template
and die-grind out the slot at the axle-attaching hole the same size as the slot in the template and de-burr the surface avoiding rounding the edges of
the slot. Refer to Figure 9.